DVB-C MUX list

This section only applies for DVB-C users. You can skip this section if you are using a DVB-S or DVB-T device.

The cable list manager manages the MUXes available for SI scanning and in tuning dialog box. The cable list manager main dialog box is shown below.

Note

Before you can use the application, you must configure at least one cable MUX here.

Operations

In the DVB-C MUX list manager dialog you can:

Add MUX
Edit MUX
Delete MUX
Scan for MUXes in your cable signal

Adding a MUX

To add a MUX fill in the parameters in the dialog and press OK button. NID and TSID should be the values for the transport stream on the transponder. It is important to enter a unique combination not already in the list.

Editing a MUX

To edit an existing MUX click on to select it. Edit the required parameters and press the OK button.

Deleting a MUX

To delete one or more MUX(es) select the MUX(es) in the list and press delete button.

Scan for MUXes

This will allow you to scan your DVB-C signal for available MUXes and populate the DVB-C MUX list manager automatically. It uses progressive tuning on standard or custom frequencies, adding MUX entries automatically when a signal is locked.

To scan standard frequencies, select 'Standard frequencies'. To scan custom frequencies, select 'Custom band scan', set a start frequency, a frequency step (e.g. 8000kHz), and an end frequency. Other parameters will vary according to your signal provider.